Casio XJ-S35 - Manual (Page 96)

96
Performing a Presentation Using the YC-400
Document Camera
This section explains how to connect the CASIO YC-400 Multi PJ Camera System (document
camera) to the Data Projector in order to project the images of documents placed on the
document stage of the document camera. The Data Projector’s built-in application named YC
Camera is used to project document images.
Important!
A YC-400 document camera can be connected to the Data Projector only if the camera
is running firmware version 1.1 or higher. For information about checking the firmware
version of your YC-400 document camera, visit the CASIO website at:
http://world.casio.com/projector/download/en/yc_400_firmup/
YC Camera is an application built into the Data Projector that makes it possible to control
the YC-400 document camera from the Data Projector. With the YC Camera application you
can project the image of documents placed on the document stage of the document camera.
Connecting the document camera to the Data Projector’s USB port and turning on the
document camera will cause the YC Camera application to start up automatically.
Connecting the Document Camera to the Data Projector
This section provides the basic steps you need to perform in order to connect the
document camera to the Data Projector and project the image of documents placed onto
the document camera’s document stage.
Important!
The procedure below assumes that the Data Projector’s plug-and-play feature is turned
on (which is the initial default setting). If you have turned off plug-and-play, turn it back
on before performing the procedure below. For more details about the plug-and-play
setting, see “Setup Menu Contents” in the User’s Guide.
YC Camera Application Function and Operation
Overview