Canon PC1270D - Manual (Page 42)

4-10
4 Press Start .
• After the scanning is finished, the machine starts to dial the number.
• The machine will first send the document to the one-touch speed dialling
destinations, then the coded speed dialling destinations, and finally to the
destination dialled using regular dialling.
• If you prefer the machine never to scan a document automatically after a few
seconds, disable the TIME OUT setting. (
→
p. 9-6)
• To cancel sending, press Stop/Reset then press (–) . Sending to all
destinations specified in step 3 will be cancelled. You cannot cancel just one
destination.
After cancelling, the machine will print a MULTI TX/RX REPORT. (
→
p. 7-4)
• If a number is busy, the machine will continue sending to the other destinations and
then redial the number that was busy.
• If the machine’s memory becomes full while scanning your document, MEMORY
FULL will appear in the LCD and the document being scanned stops in the ADF.
Press OK to make the document come out automatically. If this happens, divide the
documents into several sections and send each section separately.
▲
SB_PC1270D_FG_EN.book Page 10 Monday, February 18, 2002 12:20 PM