Casio FX-9750GII - Manual (Page 324)

A -4
Message Meaning Countermeasure
Time Out • A Solve calculation or integration
calculation was unable to satisfy
convergence conditions. • If you are performing a Solve
calculation, try changing to the
initial default estimated value.
• If you are performing an
integration calculation, try
changing to a larger
tol value.
Circular
ERROR • There is a circular reference
(such as “=A1” in cell A1) in the
spreadsheet. • Change cell contents to remove
the circular references.
Please
Reconnect • The connection was dropped for
some reason while updating the
operating system. • Reconnect and try again.
Too Many Data • The number of data items is too
large. • Delete unneeded data.
Fragmentation
ERROR • Memory must be optimized before
any more data can be stored. • Optimize memory.
Invalid Name • The file name you input includes
invalid characters. • Use the correct characters to
input a valid file name.
Invalid Type • An illegal data type is specified. • Specify valid data.
Storage
Memory Full • The storage memory is full. • Delete unneeded data.
No Card* • There is no SD card loaded in the
calculator. • Load an SD card.
SD Card Full* • The SD card is full. • Delete unneeded data.
Invalid file
name or folder
name.* • Data or folders that are supported
by this calculator cannot be found
on the SD card. • Replace the card with one that
contains data/folders that are
supported by this calculator.
Invalid Card* • A card that is not compatible with
the calculator is loaded. • Replace the card with a
compatible card.
Card is
protected* • The SD card is write protected. • Remove write protection.
Data ERROR • A data error occurred. • Check to make sure you are
writing correct type of data and try
again.
Card ERROR* • An SD card error occurred. • Remove and correctly insert the
SD card and try again. If this error
occurs again, re-format the SD
card.
Data is
protected* • The Read Only attribute of the SD
card loaded in the calculator has
been turned on using a computer,
etc. • Turn off the SD card’s Read Only
attribute.
* fx-9860G II SD only