Casio FX-9750GII User Manual

Page 338

Advertising
background image

20051101

2-9

Using the Setup Wizard

7. Press

6(DRAW) to graph the function.

• This graphs the function and displays a vertical cursor line as shown below. Use the

graph to specify the range that you want to output to the speaker.

8. Use the

d and e cursor keys to move the cursor to the start point of the output, and

then press

w to register it.

9. Use the

d and e cursor keys to move the cursor to the end point of the output, and

then press

w to register it.

• After you specify the start point and end point, an output frequency dialog box shown

below appears on the display.

10. Input a percent value for the output frequency value you want.

• To output the original sound as-is, specify 100%. To raise the original sound by one octave,

input a value of 200%. To lower the original sound by one octave, input a value of 50%.

11. After inputting an output frequency value, press

w.

• This outputs the waveform between the start point and end point from the EA-200 speaker.

• If the sound you configured cannot be output for some reason, the message “Range

Error” will appear. If this happens, press

J to scroll back through the previous setting

screens and change the setup as required.

12. To terminate sound output, press the EA-200 [START/STOP] key.

13. Press

w.

• This displays a screen like the one shown below.

/

Advertising
This manual is related to the following products: