Pro Boat PRB0600 - Manual (Page 3)

Shockwave 26
Boat Battery pack(s) Installation
1. Lift the back of the hatch and pull the hatch
backward to remove.
2. Remove the radio box cover.
3. Adhere loop tape (included) to the battery.
Do not cover the battery warning label.
4. Secure the boat battery on the hook strip in the boat.
5. Secure the battery in the hull with the hook and loop
strap as shown.
3
5
4
1 2
3
EN
Specifications
length 26 in (660mm)
Beam 4.375 in (111mm)
Transmitter 2.4GHz Pistol
Grip Transmitter
Receiver 2-channel 2.4GHz
Hull Material ABS Plastic
Motor
550 Motor (20 turn)
ESC 50 Amp brushed
Battery and Charger
DYN4113
2A peak charger
DYN1060EC 6-cell 2400mAh
Ni-MH battery
4 AA batteries (sold separately) are
required to operate the transmitter.
Recommended Tools and Materials
• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 7mm
• Phillips screwdriver: #1
• Hex wrench: 2.5mm, 3mm
• Clear tape (PRB0102)
• Pro Boat
® Marine Grease and Gun (PRB0100)
product Inspection
Carefully remove the boat and radio transmitter from
the box. Inspect the boat for damage. If you find
damage is present, please contact the hobby
shop where you purchased your boat.
Contents
Introduction
The Pro Boat ® Shockwave ® 26 ready-to-run boat is agile on the lake and easy on the eyes. It’s a high-performing,
wave-churning Deep-V hull that’s ready to tear up the water. Whether you’re new to RC boating or an experienced
pro, the Shockwave 26 brushed boat will take you on an unforgettable ride time after time.
Register your boat online at www.proboatmodels.com.