Pro Boat PRB2350S - Manual (Page 11)

11
Clean all residue off of the flex shaft with 4.
a de-greasing cleaner and wipe dry.
Liberally apply marine grease (PRB0110) 5.
to the flex shaft.
Install in reverse order, being sure to leave 6.
a 1–2mm gap between the drive dog and
the rear of the propeller strut.
Photo 1
Photo 3
Photo 2
Photo 4
Section 17: Appendix
Hull
Hatch
Boat Stand
Hatch Mounting
Screw
Drain Plug Propeller
Rudder
Cooling
Line
Fuel Tank
Exhaust
Port
Engine
Carburetor Kill Switch
Cooling
Line
Cooling
Line
Carburetor
Throttle
Cable
Spark Plug Cooling
Line
Primer
Button
Pull
Starter