Pro Boat PRB2350S - Manual (Page 4)

4 4
In addition to the items needed to run the
HyperSport 48, we recommend that you carry
the following in your field box:
Engine Tuning Screwdriver (DYN3048) •
Extra Propellers (PRB2369) •
#1 Phillips screwdriver •
8mm wrench •
Screw-locking compound •
Clean towels •
Hex wrench: 2mm, 2.5mm, 4mm •
16mm wrench (2) •
Wax •
There are 4 plywood boat stand pieces. 1.
The 2 short plywood pieces are the ends
of the boat stand.
Secure the 2 long plywood pieces of the 2.
interlocking boat stand to one end of the
short plywood pieces. Repeat with the
remaining short plywood pieces.
Unscrew the knurled hatch-mounting screw
from the rear of the hatch. Lift the hatch
from the rear and pull to the rear.
Although the HyperSport™ 48 comes fully
assembled and ready for action, you will need
a few additional items in order to run your
boat. You will need the following:
Evolution • ® Synthetic 2-Cycle Oil, quart
(EVOX1001Q)
Flex Shaft Lubrication (PRB0100) •
Fuel Pump (HAN155) •
8 AA alkaline batteries •
(4 for the transmitter and 4 for the receiver)
CA or epoxy glue •
Fuel container •
Gasoline (+87 Octane), ethanol-free •
Suggested Field Equipment
and Supplies
Section 1: Building
the Boat Stand
Section 2: Removing
the Canopy
Additional Required Items