Pro Boat PRB2350S - Manual (Page 5)

5
Receiver Batteries
Use a 2.5mm hex wrench to remove the 1.
eight 2.5mm hex head screws that secure
the radio box cover.
Remove the battery holder and install 4 AA 2.
alkaline batteries in the polarity shown on
the battery box.
Note: You may consider upgrading the
receiver battery to a rechargeable battery
pack. We recommend a 6-volt 1400mAh
3+2 hump rechargeable battery pack or
equivalent (DYN1445). See your local
Pro Boat dealer.
Wrap the battery pack in foam and reinstall
3.
the radio box cover.
Transmitter Batteries
Install the wing in the direction shown. 1.
Use two 10mm nuts to secure the 2.
wing to the hull.
Note: The wing is not intended to
be a handle.
Remove the transmitter from the box. 1.
Remove the battery cover on the bottom 2.
of the transmitter.
Insert 4 AA alkaline batteries into the 3.
battery holder.
Note the proper polarity of the batteries.
Turn on the transmitter and confirm that
4.
the LCD illuminates, indicating proper in-
stallation of fully charged batteries.
Turn on the receiver switch and move the 5.
controls. Confirm that all controls operate
in the proper direction and are controlled
by the proper transmitter input.
Turn the transmitter and the receiver 6.
switch off. To keep the boat from receiv-
ing stray signals, the transmitter should be
turned on first, followed by the receiver.
Likewise, the receiver should be turned
off first, then the transmitter.
Section 3: Installing the
Radio System Batteries
Section 4:
Installing the Wing