Pro Boat PRB3150 - Manual (Page 10)

10
The electronic speed control (ESC) features a
Ni-MH/Li-Po switch to easily change the cutoff
voltage for each battery type.
Caution: It is imperative that you do
not attempt to use Li-Po batteries in the
ShockWave 26 Brushless unless the cutoff
switch is in the Li-Po position or serious
damage to the batteries and electronics
may occur.
Note: Do not turn off the transmitter first
or the receiver may run out of control.
Before and at the end of each run, make sure
all screws are tight and the propeller is free
from any entanglement.
Lubricating the drive system is vital to the life
of the drivetrain. The lubricant also acts as a
water seal, keeping water from entering the
hull through the stuffing box.
Lubricate the drive shaft, propeller shaft
and all moving parts after every 2–3 hours
of operation.
 1. Use a 1.5mm hex wrench to loosen the
setscrew connecting the flex shaft to the
motor adapter.
Speed Control Programming
Maintenance
Lubricating the Drive Shaft