PS Engineering PMA8000BT NUI Pilot’s Guide User Manual

Page 17

Advertising
background image

202-890-0702

Page 17

Sept. 2014 PMA8000BT Pilot Guide

“Music” Distribution Function

The Music Function has three modes. To cycle Music distribution modes,

press and hold Mute button until the annunciation starts.

When “Music number one, all headsets” is selected, Music 1
(Bluetooth source, or rear connector) will be distributed to all
headsets and is independent of the intercom mode switch.
Therefore, even in the CREW mode, the passengers will hear
Music 1, although though they will not hear the crew intercom

or radios.
This mode allows you to use a single in-flight entertainment source. The
music muting follow the selected mode of the crew and passengers.

When you press “Music” function again, you’ll hear, “Alternate music distribution.

This function makes Music 2 dependent on the intercom mode.

In this state, Music 2 will be heard only when the intercom is in the CREW mode,
and only the passengers will hear it. Music 1 (Bluetooth, Rear input, and Front Panel
Jack) will be provided to passengers’ headset in ISO and ALL intercom modes.
Press again, and you will hear “Standard Music Distribution.” In this mode, Music 2
becomes active, and will always be presented to the passengers. Music 1 is only
available to the pilot and copilot. The intercom mode switch will not have any affect
on the music distribution.

When the music is in “Standard music distribution,” Music 1 will always go
to the pilot and copilot positions, and is never heard by the passengers. Mu-
sic 2 is always heard by the passengers, and never heard by the pilot and
copilot.
This mode is useful if your passengers have a different interest in entertain-
ment or are watching a DVD, but do not want to be excluded from the inter-
com conversations.
Alternate Music distribution modes are announced at power up, unless the
power on announcement has been defeated.

Power on announcement

If the Intercom or Music Distribution is changed from the
factory default, the configuration will be played when the
unit is powered up. To defeat this announcement, hold the
TEL and AUX buttons for two seconds. The feature can be enabled using the
same sequence.

Music Muting

There are two SoftMute™ muting circuits. The front panel "Mute" button
has four modes, and controls the Mute function for music 1.
The SoftMute™ circuit will cut the music out whenever there is conversation
on the radio, the intercom, or both, depending on the “Mute” mode selected.
When that conversation stops, the music returns to the previous level com-
fortably, over a second or so.
The mute mode functions are controlled through sequential pushes of the

Advertising