Ram Trucks 2011 3500 - User Guide - Manual (Page 24)

SPEED CONTROL LEVER
Cruise ON/OFF
• Push the ON/OFF button to activate
the Speed Control.
• The cruise symbol or CRUISE
will appear on the instrument cluster
to indicate the Speed Control is on.
• Push the ON/OFF button a second
time to turn the system off.
Set
• With Speed Control on, push down
and release the lever to set a desired
speed.
Accel/Decel
• Push and hold the lever up to accelerate or down to decelerate the vehicle;
release the lever to save the new set speed.
• Once a speed is set, tapping the lever up or down will increase or decrease
the set speed approximately 1 mph (2 km/h).
• Push and hold the lever up to accelerate in 5 mph (8 km/h) increments or push
and hold the lever down to decelerate in 5 mph (8 km/h) increments; release
the lever to save the new set speed.
Resume
• To resume a previously selected speed in memory, push the lever up and
release.
Cancel
• Pull the lever toward you, push the clutch pedal or apply the brakes to cancel
the set speed and maintain the set speed in memory.
• Push the ON/OFF button to turn the system off and erase the set speed
memory.
WARNING!
• Leaving the Electronic Speed Control system on when not in use is
dangerous. You could accidentally set the system or cause it to go faster than
you want. You could lose control and have a collision. Always leave the
Electronic Speed Control system off when you are not using it.
(Continued)
OPERATING YOUR VEHICLE
22