Ram Trucks 2011 3500 - User Guide - Manual (Page 27)

Air Conditioning (A/C)
• If the A/C button is pushed while in the AUTO mode, the indicator light may
flash three times to indicate the cabin air is being controlled automatically.
SYNC Temperature Button
• Push the SYNC button once to control the driver and passenger temperatures
simultaneously. Push the SYNC button a second time to control the
temperatures individually.
Air Recirculation
• Use recirculation for maximum A/C operation.
• For window defogging turn the recirculation button off.
• If the recirculation button is pushed while in the AUTO mode, the indicator
light may flash three times to indicate the cabin air is being controlled
automatically.
PARKSENSE ® REAR PARK ASSIST
• If an object is detected behind the rear bumper while the vehicle is in
REVERSE, a warning will display in the instrument cluster and a tone, that
changes speed depending on the distance of the object from the bumper, will
sound.
• When the Instrument Cluster reads either “Clean Sensor” or “Blinded”, clean
off the bumper sensors to see if the condition is corrected.
Enable/Disable ParkSense ®
• ParkSense ® can be enabled and disabled with a switch located in the switch
bank of the instrument panel or through the Customer-Programmable Features
section of the EVIC. When the switch is pressed to disable the system, the
instrument cluster will display the “PARK ASSIST SYSTEM OFF” message for
approximately five seconds.
PARKVIEW ® REAR BACK-UP CAMERA
• You can see an on-screen image of the rear of your vehicle whenever the shift
lever is put into REVERSE. The ParkView ® Rear Back-Up Camera image will
be displayed on the radio display screen, located on the center stack of the
instrument panel.
• If the radio display screen appears foggy, clean the camera lens located on the
tailgate.
OPERATING YOUR VEHICLE
25