Programmable features, Key fob programmable features, Electronics – Ram Trucks 2011 3500 - User Guide User Manual

Page 51

Advertising
background image

PROGRAMMABLE FEATURES

Electronic Vehicle Information Center (EVIC) – If Equipped

• The EVIC can be used to program the following Personal Settings. Press the

UP

or DOWN

button until SYSTEM SETUP displays, then press the

SELECT button

. Scroll through the settings using the UP or DOWN

button. Press the SELECT button to change the setting.

• Select Language

• Headlamp Off Delay

• Nav-Turn By Turn

• Headlamps With Wipers

• Auto Door Locks

• Wiper Mode – If Equipped

• Auto Unlock Doors

• Easy Exit Seat – If Equipped

• Remote Unlock Sequence

• Tilt Mirror In Reverse

• RKE Linked To Memory

• Key-Off Power Delay

• Remote Start Comfort Sys.

• Illuminated Approach

• Horn With Remote Start

• Compass Variance

• Horn With Remote Lock

• Calibrate Compass

• Flash Lamps With Lock

Key Fob Programmable Features

• The following features may also be programmed by using the Key Fob

transmitter or the ignition switch and driver's door lock switch.

NOTE: Pressing the LOCK button while you are inside the vehicle will activate the
Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated
will cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle
Security Alarm.

Unlock On First Press

• To unlock either the driver's side, or all doors, on the first press of the

UNLOCK button:

• Press and hold the LOCK button for at least 4 seconds, but no longer than

10 seconds. Then, press and hold the UNLOCK button while still holding the
LOCK button.

• Release both buttons at the same time.

Auto Unlock Doors On Exit

• To have all of the vehicle doors unlock when any door is opened:

• Enter your vehicle, close all the doors and fasten your seat belt.

• Within 15 seconds, cycle the ignition switch from the OFF position to the ON

position a minimum of four times, ending in the OFF position (do not start
the engine).

• Within 30 seconds, press the driver’s door lock switch in the UNLOCK

direction. A single chime will indicate that programming is complete.

ELECTRONICS

49

Advertising
This manual is related to the following products: