Ram Trucks 2014 ProMaster Commercial - Owner Manual - Manual (Page 155)

Tuner Mode (AM/FM Radio)
When you enter TUNER mode, the radio tunes to the
most recently selected station and will remain on the
most recently selected frequency band.
In this mode of operation the display will show one of the
following 5 codes:
CH (Channel)
When this is on, it indicates that the current radio station
is stored in memory. The code is only shown when the
tuned frequency is showing on the display.
ST (Stereo)
When this is on, it indicates that the radio station is
transmitting a 19 kHz signal (pilot).
Searching for Stations In Automatic Mode
When you press or for less than two seconds, the
radio will search for the next valid station. While the
radio is searching for the new station, the display will
show
ЉSEEKINGЉ. When the search is complete, the
display will show the tuned frequency band and
station in the format
ЉF1 106.9Љ or, if the station was
previously stored in memory, the display will show
the channel where it is stored and the tuned station.
Searching for Stations In Manual Mode
Pressing or for more than two seconds displays
the selected radio station frequency. Each time a
button is pressed, the radio station frequency is in-
creased or decreased according to the default search
pattern for the selected band (100 kHz for FM and 10k
Hz for AM). When the search button is pressed and
held, the radio station frequency will continue to be
increased or decreased. If the buttons are not pressed
for five seconds, the display will show the message
ЉAUTOЉ and manual search mode will be canceled.
When the search is complete, the display will show the
tuned band and station in the format
ЉF1 106.9Љ, or, if
4
UNDERSTANDING YOUR INSTRUMENT PANEL 153