Ram Trucks 2014 ProMaster Commercial - Owner Manual - Manual (Page 156)

the station found was previously stored in memory,
the display will show the channel where it is stored
and the tuned station.
Mute/Pause
Pressing this button mutes the sound. The display will
switch between
ЉMUTE ONЉ and the previous display (3
seconds).
Pressing the button again restores the audio without
changing the original volume setting. The display will
show
ЉMUTE OFFЉ for three seconds, and then return to
the previous display mode.
When the or , Audio, 1, 2, 3, 4, 5, 6, BAND/AS
buttons and SRC are pressed in
ЉMute / PausedЉ
mode, these will be implemented and the audio will
be restored without changing the original volume.
Turn the ROTARY knob to restore the audio and change
the volume to the level selected. The display will show
the settings described in the volume function.
The other buttons should be implemented when pressed,
but the radio will remain in
ЉMUTE ONЉ mode.
Storing Stations In Memory
Press and hold the memory buttons (1 through 6) for
more than two seconds to associate the tuned station
with the pressed button. The display will show a message
in
ЉMEMO 2Љ format for three seconds to confirm that the
station has been tuned in. The CH signal is then activated
and the display will show the preset number and station
frequency for three seconds
Љ2 106.9Љ. The display will
then return to the previous view.
154 UNDERSTANDING YOUR INSTRUMENT PANEL