SeaLand DTD01 Discharge Pump Control - Manual (Page 8)

8
Dometic Tank Discharge Control Installation
7.1 OPTION 1: DTD01 discharge control panel only (fig. 4 , page 3)
1 . When boat is in unrestricted waters and pump-out is desired, insert key into switch and turn to
momentary “Start” position (1).
2. Allow key to rebound to “Pump On” position (2). Green light indicates that pump is running.
3. When pump-out is complete, turn key to “Off” position (3) and remove key from switch.
4
7 Operation
6.3 Key to DTD01-DTM04 system wiring (fig. 7 , page 4)
Ref. Description
A DTD01 control panel
B Discharge pump
C DTM04 indicator panel
D Wastewater tank
E 12 or 24 V DC
F V DC ground
G Discharge pump circuit breaker or fuse
H 12 V DC
I 24 V DC
J 1-amp circuit breaker or fuse
K Toilet system circuit breaker or fuse
7
Ref. Description
L + V DC to electric toilet system
M Full level probe
N Mid level probe
O Low/Empty level probe
P Red
Q Black
R Brown
S Green
T Blue
U Yellow
V Orange
6.2 Key to DTD01 - discharge pump system wiring (fig. 5 , page 3)
Ref. Description
A DTD01 control panel
B Discharge pump
C 12 or 24 V DC
D V DC ground
5
Ref. Description
E Discharge pump circuit breaker or fuse
F Red
G Black
H Brown
1. Use 14 gauge or larger diameter standard copper wire.
2 . Maximum discharge pump circuit breaker or fuse rating: 20 amps .
1 . Heavy line indicates 14 gauge or larger stranded copper wire is required .
2 . Other wire can be 18 gauge stranded copper wire or larger .
3 . Maximum discharge pump circuit breaker or fuse rating: 20 amps .