Use rapid-dissolving toilet tissue – avoid clogs, Troubleshooting – SeaLand 7200 Series MasterFlush Toilet Quick-start Guide User Manual

Page 3

Advertising
background image

4

DO NOT FLUSH FOREIGN OBJECTS

CAUTION! Flush only water, bodily wastes and rapid-dissolving tissue
paper. Do not fl ush wet wipes, sanitary napkins, condoms, diapers,
razor blades, paper cups, cotton swabs, food, hair or liquids such as
oils or solvents. Clogging or damage to the toilet system may occur.

Note
Make sure all guests understand toilet operation before use.

Use RAPID-DISSOLVING toilet tissue – avoid clogs

To avoid potential clogging problems with some household tissues,
Dometic recommends the use of quick-dissolving tissue, such as
SeaLand

®

Rapid-dissolving 1-ply or 2-ply Toilet Tissue.

IMPORTANT! NOT EVERY MARINE-GRADE TOILET
PAPER DISSOLVES RAPIDLY

To determine any tissue’s ability to dissolve, immerse one square of
tissue in a jar of water and shake 5-10 times. The tissue sample
should break up so that it is no longer in one piece.

Troubleshooting

Problem

Possible Cause

Service Instruction

1. Flush function works,

but water in bowl
empties slowly or not
at all.

a. Discharge piping is pinched or

kinked.

b. Discharge piping is too high.

(Remember, all upward vertical
loops and should not exceed a
total of 4 feet (1.2 m) in height.)

c. The macerator pump or

discharge piping is blocked.

a. Check discharge piping.

b. Reroute discharge piping.

c. Close seacocks and clear

blockage.

2. Macerator pump

makes unusually loud
noise or continually
trips breaker.

a. Foreign material in pump

chamber.

a. Close seacocks and clear

foreign material.

3. Flush cycle is not

activated after
pushing on fl ush
switch.

a. Holding tank is full and signal

from tank has shut down
electrical power to toilet.

b. Electrical power to toilet is shut

off or disrupted.

c. Flush switch is malfunctioning.
d. Electric motor is malfunctioning.

a. Empty holding tank.

b. Check wiring and circuit

breakers (or fuses).

c. Replace fl ush switch.
d. Replace electric motor.

4. Insuffi cient or

no water enters
the bowl.

a. Water supply line is pinched or

kinked.

b. Screen in water valve is blocked.

c. Intake water fi lters are blocked

(in sea water system).

d. Water valve is malfunctioning

(fresh water fl ush toilet).

e. Water impeller is malfunctioning

(sea water fl ush toilet).

a. Check water supply line.

b. Clear blockage at water

valve.

c. Clear water fi lters.

d. Replace water valve.

e. Replace sea water

impeller.

Advertising
This manual is related to the following products: