SIG SAUER P938P - Manual (Page 42)

www.sigsauer.com 42
4. guide the slide assembly onto the frame rails from the front until the barrel lug
is aligned with slide stop pin hole in frame and partially insert slide stop pin.
- note: depress the ejector “a” to clear slide.*
The ejector should be depressed only far enough to provide clearance for the
slide during assembly. depressing the ejector beyond the point required for
reassembly may cause the ejector to bind in the frame. Should this occur, the
ejector will not return to the normal position. This condition is not correctable at
the operator level - the pistol will have to be returned to Sig Sauer
® for repair.
5. retract slide rearward until slide disassembly notch is aligned with slide stop tab.
6. Press slide stop inward until fully seated and release slide.
Slide Stop Tab
disassembly notch
A*
Step 4
Step 5
Step 6
W
caution
oVeR eXtension of the eJectoR duRing
assembly may cause the eJectoR to
bind, PReVenting shell casings to eJect
duRing fiRing.