SilentKnight SKE-450 Voice Evacuation Control Panel - Manual (Page 61)

151267 8-1
Section 8
SKE-V70 Module Installation
The SKE-V70 converts the speaker circuit voltage from 25 Vrms to 70.7 Vrms. The following
sections describe how to install and wire the SKE-V70.
8.1 Mounting
Follow these steps to install the SKE-V70 module into the main control panel cabinet:
1. Unlock and open the cabinet door.
2. Remove the two cover plate retaining screws, then open the control panel cover plate. See
Figure 8-1.
Figure 8-1 View of Cabinet With Cover Plate in Place
Note: The control panel cover plate can be remove by removing the Hinge screw.
3. Run all wire needed to install the system at this time. See Section 8.2.
Control Panel
Cover Plate
Control Panel
Cover Plate
Zone Splitter
Access Plate
Retaining Screws
Hinge Screw