Slant/Fin Line 30 - Manual (Page 12)

replace front cover...
BASELINE 2000, FINE/LINE 30 & MULTI/PAK 80
Place lower edge underneath lower bracket.
Lift slightly and press upper edge forward
with thumb till panel snaps into place.
For a neat finish at partitions, use the wall
trim (adjustable up to 3
1 ⁄
2
”
). Air vents are
recommended at each drop; either wall
trim or end caps (both hinged) provide
easy access to vent. These accessories
eliminate the wasteful need for cutting
large baseboard units to fit small gaps,
and save you time and effort. Attractive
inside and outside corners assure a
custom look.
snap on the accessories...
WALL TRIMS, END CAPS, CORNERS
FINE/LINE 15
Place top edge of front panel on bracket
with panel in “up” position, swing down.
Important: to lock the panel to the brack-
et, pull cover outward away from bracket,
while swinging down. Push bottom of
panel to engage lower bracket.
FILLER SLEEVE, SPLICE PLATES
The Filler Sleeve has 4 parts: back
piece, damper sleever, top sleeve, front
sleeve. The Splice Plate is exactly the
same, but without a back piece.
12