Program settings (dip switch s1), Program setings (dip switch s2), Program settings (dip switch s2) – Chamberlain LIFTMASTER PROFESSIONAL SW470 User Manual
Page 26
26
Min = 0 sec
Max = 180 sec
TIMER-TO-CLOSE ENABLE
This switch enables the auto close timer. The timer to close
feature works in conjunction with the potentiometer located on
the board.
SLIDE/SWING
This switch selects slide or swing gate operation, in order to
optimize gate behavior for specific application.
SL = Slide • SW = Swing
RIGHT/LEFT OPERATION
This switch selects the gate opening direction, to the left or to
the right. Right/Left operation is determined from the inside of
fence looking out.
“SAVE” SWITCH
This switch stores all settings into memory and locks out changes.
NOTE: For any programming changes to take effect this switch
must be in OFF position. When switch is ON, no settings can be
changed.
R
T
L
T
SW SL
1 2 3 4
ON
SA
VE
TTC
ON
S1
1 2 3 4
ON
SA
VE
TTC
ON
S1
R
T
L
T
SW SL
APEMs
ON
CLED PH
OPED PH
1 2 3 4
W
ARN
MAG
ON
S2
ON
CLED PH
OPED PH
1 2 3 4
W
ARN
MAG
ON
S2
ON
CLED PH
OPED PH
1 2 3 4
WA
R
N
MAG
ON
S2
ON
CLED PH
OPED PH
1 2 3 4
WA
R
N
MAG
ON
S2
1 2 3 4
ON
SA
VE
TTC
ON
S1
1 2 3 4
ON
SA
VE
TTC
ON
S1
R
T
L
T
SW SL
R
T
L
T
SW SL
PROGRAM SETTINGS (DIP SWITCH S1)
NOTE: For all S1, S2 and S4 switch settings to take effect, the Save Mode switch must be set to the off position.
PROGRAM SETTINGS (DIP SWITCH S2)
MAGLOCK ENABLE
This switch enables the Maglock feature. On an open command
there will be a half second delay after the maglock relay is
released before the motor starts.
WARNING ENABLE
This switch enables the gate “in motion” alarm feature. The
alarm will beep 3 seconds prior to movement and throughout
movement.
TIMER-TO-CLOSE
1 2 3 4
ON
SA
VE
TTC
ON
S1
1 2 3 4
ON
SA
VE
TTC
ON
S1
R
T
L
T
SW SL
R
T
L
T
SW SL
1 2 3 4
ON
SA
VE
TTC
ON
S1
1 2 3 4
ON
SA
VE
TTC
ON
S1
R
T
L
T
SW SL
R
T
L
T
SW SL
(Factory Default)
TIMER-TO-CLOSE
ENABLED
SWING GATE
SLIDE GATE
TIMER-TO-CLOSE
DISABLED
(Factory Default)
LEFT HAND
RIGHT HAND
(Factory Default)
LOCKED
UNLOCKED
(Factory Default)
MAGLOCK ENABLED
MAGLOCK DISABLED
(Factory Default)
WARNING ENABLED
WARNING DISABLED
(Factory Default)