Triner Scale TMU-295 - Manual (Page 63)

Commands 5-23
[Description] Sets the time that the printer waits for slip paper to be inserted and
the time from insertion of the sheet to the start of printing.
• t1 specifies the wait time for a cut sheet to be inserted. There is no
limitation for the wait time and the printer waits until slip paper is
inserted.
• t2 specifies the time from insertion of the sheet to the start of
printing.
• The printer starts operation [t2
×
0.1] seconds after detecting slip
paper.
[Note] When either t1 or t2 is out of the specified range, this command does
not change the previously set wait time.
[Default] t1 = 0, t2 = 10
ESC p m t1 t2
[Name] Generate pulse
[Format] ASCII ESC p m t1 t2
Hex 1B 70 m t1 t2
Decimal 27 112 m t1 t2
[Range] m = 0, 1, 48, 49
0
≤
t1
≤
255
0 ≤ t2 ≤ 255
[Description] Outputs the pulse specified by t1 and t2 to connector pin m as
follows:
[Notes] • The pulse ON time is [t1 ✕ 2 ms] and the OFF time is [t2 ✕ 2 ms].
• If m is outside the specified range, the printer ignores this
command and the following data is processed as normal data.
ESC q
[Name] Paper release
[Format] ASCII ESC q
Hex 1B 71
Decimal 27 113
[Description] Releases the paper
[Notes]
• This command is available only in standard mode.
• When the panel button is disabled and the specified paper sensor
detects a paper-end, the printer releases the paper, regardless of
this command.
m Connector pin
0, 48 Drawer kick-out connector pin 2
1, 49 Drawer kick-out connector pin 5