Triner Scale TMU-295 User Manual
Page 64
5-24
Commands
[Reference]
ESC c 4
, ESC c5
ESC t n
[Name]
Select character code table
[Format]
ASCII
ESC
t
n
Hex
1B
74
n
Decimal
27
116
n
[Range]
0
≤
n
≤
2
[Description] Selects a page n from the character code table.
[Note]
If n is outside the specified range, the printer ignores this command.
[Default]
n = 0
ESC u n
[Name]
Transmit peripheral device status
[Format]
ASCII
ESC
u
n
Hex
1B
75
n
Decimal
27
117
n
[Range]
n = 0, 48
[Description] Transmits the status of connector pin n upon receiving this
command, using n as follows:
[Notes]
• When the connector is not used, the value of bit 0 is always 1.
• When DTR/DSR control is selected, the printer transmits only 1
byte after confirming that the host is ready to receive data (DSR
signal is SPACE). If the host computer is not ready to receive data
(DSR signal is MARK), the printer keeps waiting until the host is
ready. When XON/XOFF control is selected, the printer transmits
only 1 byte without checking the DSR signal.
• This command is executed when the data is processed in the
receive buffer. Therefore, there may be a time lag between
receiving the command and transmitting the status, depending on
the receive buffer status.
n
Page
0
0
(PC437 [U.S.A., Standard Europe])
1
1
(Katakana)
2
2
(PC850 [Multilingual])
n
Connector pin
0, 48
Drawer kick-out connector pin 3