TruTrak Sorcerer – Outdated - Manual (Page 16)

15
However, it may be set to any
of 600, 1200, 2400, 4800, or
9600 baud. Consult the manual
for the GPS unit and follow its
setup instructions to determine
its setting and set the baud rate
of the autopilot to the same
value. The autopilot will
recognize NMEA-0183
protocol, Garmin protocol, or
Apollo GX50/GX60 protocol
(moving map output).
Once the desired baud rate
has been selected, again push
the up control on the vertical
speed rocker to enter the
selected value into storage, and
advance to the next setup
screen, which is shown below.
The
BANK ANGLE setup
screen allows a low, medium, or
high setting. This will limit the
autopilots maximum bank angle
to approximately 13 degrees at
the low setting, approximately
18 degrees at the medium
setting, and approximately 24
degrees at the high setting.
Once the desired maximum
bank angle has been selected,
again press the up control on the
vertical speed rocker to advance
to the next setup screen, which
is shown below.
The next setup screen is
MICROACTIVITY. This
setting is to be left at zero
unless advised by the factory.
Press the up control on the
vertical speed rocker to advance
to the next setup screen, which
is shown below.
The next setup screen is
GPSS GAIN. This setting
should be left at 16 unless
advised by the factory. Press
the up control on the vertical
speed rocker to advance to the
next setup screen, which is
shown below.
This setup screen is to turn
the speech annunciation on and
off. If the speech is turned off,
the autopilot will give a series
of alerter tones for important
information. If the speech is
turn on, there will be a voice
annunciation for important
information. Once this has been
set, press the up control on the
vertical speed rocker to advance
to the next setup screen, which
is shown below.
The next setup screen is for
AUDIO LEVEL. While this
screen is displayed, the
autopilot will send an audio