TruTrak Sorcerer – Outdated - Manual (Page 19)

18
The next screen in the pitch
setup sequence allows
adjustment to compensate for
the lag (delay) in the aircraft’s
static system. Select the lowest
value over the range 0 to 2
which results in the elimination
of “hunting” in the altitude hold
mode. This adjustment should
be done in still air at cruise
airspeed. Press the up control
on the vertical speed rocker to
advance to the next setup
screen, which is shown below.
This setting in most cases
will not need to be adjusted. If
this is set to Y (yes), then the
pitch servo will have a higher
resolution and take smaller
steps. However, it will also
have less available torque. This
setting should be left at N (no)
unless it is observed that the
nose moves up and down very
slightly in very still air. Once
this setting has been completed,
push enter, to exit the vertical
setup mode and return to the
normal flight screen.
The next setup screen is
MICROACTIVITY. This
setting is to be left at zero
unless advised by the factory.
Press the up control on the
vertical speed rocker to advance
to the final setup screen, which
is shown below.
This concludes the vertical
setup portion of the Sorcerer
autopilot.