Yaw damper, Vertical modes, Altitude hold mode – TruTrak Sorcerer – Outdated User Manual

Page 8

Advertising
background image

7

COURSE

navigation should not

be used when GPS track is
absent. The VNAV mode will
also not be functional without a
GPS signal. When in the gyro
backup mode the number
displayed below

BANK

is the

selected bank angle. Rotating
the encoder knob will move the
selected bank angle one degree
at a time up to five degrees, the
bank angle is then selectable in
five degree steps up to 30
degrees.


If the aircraft continues to

turn when a bank angle of zero
degrees has been selected, push
in on the encoder and the
display changes to show a

TRIM

adjustment. This adjustment is
selectable in increments of 0.2
degrees per minute up to ten
degrees per minute in either
direction. Every time the trim
is adjusted it will add the
displayed number to the current
trim adjustment.



Yaw Damper

The Yaw Damper can be

used whether or not the
autopilot is engaged. It
automatically comes on when
the autopilot is engaged. When
the autopilot is not engaged the
Yaw Damper can be toggled on

or off by pressing the [TRK]
button. If the autopilot is not
engaged, the yaw damper will
automatically disengage at the
user selectable minimum
airspeed. When the autopilot is
not engaged, and the yaw
damper is engaged the display
will be as shown below.



Vertical Modes

When the autopilot is
engaged, it will synchronize to
the vertical speed being flown
at the time, and thus will be in
the basic vertical speed-
operating mode (see figure on
page 3). While in this basic

vertical speed

mode, the upper

right section of the display
shows altitude and the lower
right section shows

SVS

(selected vertical speed). This
mode is also entered by
pressing either end of the
vertical speed rocker. If the
system is in transition to a
selected altitude pressing the
appropriate direction of the
vertical speed rocker will
switch from airspeed to vertical
speed. It will not cancel the
selected altitude, unless the
selected vertical speed is in the
opposite direction.

Altitude Hold Mode

Press

[ALT] to select ALT

HOLD mode. The selected
altitude will be to the nearest
100 feet as viewed on the

Advertising