TruTrak Sorcerer – Outdated - Manual (Page 18)

17
setup screen appears. This
screen shows the current value
for the activity with an
underline under the present
setting of activity. A typical
screen might show:
Turn the encoder knob to
set the activity level to the
desired value for the particular
aircraft. Any value between 0
and 24 may be chosen.
Once activity is set to the
desired value, press the up
control on the vertical speed
rocker to advance to the next
setup screen, which is shown
below.
In a manner similar to
activity, use the encoder knob to
select the desired value of pitch
servo torque. This value should
be between 8 and 12. A default
value is set at the factory but
may need to be modified to suit
a particular aircraft. The value
chosen should be sufficient to
fly the aircraft, but not so much
that it is difficult to override the
autopilot if necessary.
Having selected the desired
torque level, again press the up
control on the vertical speed
rocker to advance to the next
setup screen, which is shown
below.
Use the encoder knob to
select the minimum airspeed at
which the autopilot will fly the
aircraft. This speed should be a
safe margin above a stall. Press
the up control on the vertical
speed rocker to advance to the
next setup screen, which is
shown below.
Use the encoder to select
the maximum airspeed at which
the autopilot will fly the
aircraft. This should be safely
below red line, but above cruise
speed. Once this value has been
set, press the up control on the
vertical speed rocker to advance
to the next setup screen, which
is shown below.
Select, using the encoder
knob, the default value most
commonly used for a climb to a
selected altitude. Press the up
control on the vertical speed
rocker to advance to the next
setup screen, which is shown
below.