TruTrak Sorcerer – Outdated - Manual (Page 9)

8
digital altimeter. For example,
pressing enter between 4950
and 5050 will select 5000.
Vertical GPS
Steering Mode
Pressing the [GPSV]
button will enter vertical GPS
steering mode. In the GPSV
mode the autopilot follows
vertical steering commands
generated by a navigation
system (EFIS or GPS). If there
is a vertical steering signal
present, the autopilot can also
be engaged with [GPSV]
button, and it will engage in the
GPSS and GPSV mode.
When in the GPSV mode, the
display will be as shown below.
NOTE: If there is not a
vertical GPS steering signal
present the [GPSV] button
will not function.
Barometer set
NOTE: (SORCERER ONLY)
The barometer must be set
prior to using the altitude
select feature. To enter the
BARO SET screen, press and
hold [SEL], for approximately
three seconds. The display will
show the following screen.
Rotate the encoder to
match the displayed number to
the current barometer setting;
the default will always be
29.92. When this is done press
enter. If the displayed altitude
is not correct, adjust it by
rotating the encoder knob.
Press enter to accept the current
altitude and exit the barometer
set mode.
When the autopilot is
engaged and in altitude hold,
upon exit of the barometer set
page the autopilot will climb or
descend to the current selected
altitude.
Altitude Select Mode
NOTE: (SORCERER ONLY)
Pressing [SEL] will display the
SEL ALT set up screen.
The barometer must be
set prior to using the altitude
select feature. If the
barometer is not set prior to
attempting to enter the
altitude select screen the
display will show the
following screen. To set the
barometer see Barometer set
in the previous section.
If the barometer set has been
done the display will show the
following screen.