Uncle Milton Fire and Ice Prehistoric Volcano User Manual

Fire & ice prehistoric volcano

background image






Installing Batteries

Tool required - Small Phillips

head screwdriver

1. Using a Phillips head screwdriver, loosen

the screw in the battery cover and remove

the battery cover as shown.

2. Insert 3 "AAA" batteries (not included) as

indicated in the battery compartment.

3. Replace battery cover and tighten screw.

Items needed
To begin your volcanic eruption experiments you
will need to provide the following items:
• Liquid dish soap
• Baking soda
• Vinegar
• Food coloring (red and yellow)
Optional ingredients for experiment 2:

Club soda (a new, unopened bottle will work best)

Antacid tablets (for use under adult supervision)

6. Place ice volcano on the base and push the button to turn the

light on.

7. You are now ready to experiment – see eruption experiments

on other side.

4. After ice is completely frozen remove Volcano from freezer and

remove Ice Mold Plug.

5. To remove your ice volcano from the plastic mold, let it stand for 5

minutes. Gently tap the mold to release the ice volcano. If needed,
hold the Volcano as shown allowing warm water to run into and
over the TOP plastic surface ONLY. This will help release the ice
volcano to drop out of the mold.

2. Fill with water as close to top edge as shown.
3. Carefully place in freezer so that it is level and will not fall

over and allow to freeze overnight.

NOTE: Before removing the Volcano from the freezer, be

sure to have all the ingredients for your eruption experi-
ments ready.

Ice Volcano Preparation
The inside of the Volcano can be used to make an ice volcano
mold. To freeze your own ice volcano, follow the steps below.

1. Turn the Volcano upside down and place the Ice Plug

over the Volcano Tube.

Ice Plug

Volcano Tube

Light ON/OFF



Light-up Erupting Volcano Lab

• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the
toy before being charged.
• Rechargeable batteries are only to be charged
under adult supervision.
• Different types of batteries or new and used
batteries are not to be mixed.
• Batteries are to be inserted with the correct
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
• Do not dispose of batteries in fire. Battery may
explode or leak.

Fire (Earth) Volcano Set up
1. Place the Volcano on the Base

as shown. Note that the parts fit
only one way.

2. You are now ready to experi-

ment – see eruption experi-
ments on reverse side.