USL JSD-100 Manual - Manual (Page 16)

Page 16
Communication Ports
DB25F pulse automation.
Serial control – RS-232.
USB for laptop setup.
Ethernet 10/100 - RJ45.
Front Panel Interface
Eleven buttons: COAX1, COAX2, TOSLINK, DIGITAL 16 CH, USER 1, USER 2, ANALOG 8 CH, NON/SYNC, AUX,
MIC, and MUTE.
Main Fader – 0-10 used for main audio and bypass audio.
Front panel displays fader level and selected format. Bar graphs display output levels.
USB connector.
Power switch and power supply status LEDs. Turning power off activates bypass mode.
Format Selection
Digital (COAX1, COAX2, TOSLINK, 8 or 16 Channel AES/EBU).
Analog (8 channel, Non-Sync, Auxiliary, Microphone).
User 1, User 2 (Configurable in software, e.g., digital 16 channel at lower level, 7.1, 13.1, etc.).
Rear Panel Connectors – Main Chassis
PA Microphone – XLR / ¼” phone jack.
Calibration Microphone – 3.5mm stereo jack.
Eight Channel Analog – DB25F.
Non/Sync – two RCA jacks.
AUX – two RCA jacks.
Hearing Impaired and Visual Narration – pluggable Phoenix connector.
COAX1 and COAX2 – RCA Jacks with transformer input
TOSLINK – Optical.
16 Channel Digital AES/EBU – DB25 and Dual RJ45.
Removable Memory Card – SD compatible.
Serial Control – RS-232 on DE9F.
Pulse Automation – DB25F.
10/100M Ethernet – RJ45.
DC 12V Power Connector – 5mm with 2.5mm pin.
AC Power – IEC socket. 100-240VAC, 50/60Hz, 18W typical, 7.5W sleep.
Rear Panel Interface Module
All rear panel interface modules include an RJ-style connector for “USL-Link.” This IEEE 485 bus is used for
remote volume controls and other control functions. The analog rear panel modules use an RJ25 connector for
USL-Link. The AES module uses an RJ45 for USL-Link and other signals.
JSD-100x (no second suffix letter) – Eight channel analog, one DB25M and one Phoenix connector (20 pins).
JSD-100xA – 16 channel analog output module – Two DB25M and two Phoenix connectors. Outputs
configurable as crossover outputs or additional channels.
JSD-100xD – AES/EBU digital output module - 32 output channels on 16 AES pairs (4 RJ45 connectors).
Processing
96 kHz processing.
One-third octave equalization on all channels except LFE, HI, and VI-N.
Parametric equalizers on LFE.
Synchronization delays for all inputs.
Surround delays for all surround channels.