USL JSD-100 Manual - Manual (Page 28)

Page 28
The other sections of this screen cannot be changed through the summary tab.
Theater Information
The data in the theater information fields is not used by the JSD-100, but is stored in the JSD-100 for the
convenience of the user. Fill in the desired information. This data will be saved with other configuration
information in the JSD-100 and displayed the next time the unit is connected to.
Component Information
Various pieces of information about the JSD-100 are shown here. The Output Module field shows the type of
output module (Analog 8, Analog 16, or AES32). The PIC firmware version identifies the firmware version in two of
the microcontrollers and the circuit board revision of the main circuit board. In the sample screen above, the first
“D” indicates this is board Revision D. The 120425 is the revision of the main processor firmware. The 110829 is
the revision of the rear panel processor firmware. This tab also shows the versions of the firmware for each of the
two digital signal processors and the version for the GUI software itself. Each of these version numbers can be
compared with later updates to determine if the latest firmware is already installed.
Network Information
This is the network information that was set with the JSD-100 Set IP Utility, discussed Section 7.3.
7.4.6.2 Formats Tab
The “Formats” tab allows the setting of “Per-Format” configuration. These settings apply only to a specific format.
The type of settings available varies by format type. The available settings for each format are listed below. In
addition to those listed, the Lc/Rc source can be selected if the channel configuration includes Lc/Rc speakers (such
as 7.1SDDS). Select the format that is to be configured using the format buttons on the GUI or the JSD-100 front
panel.
Format Settings
Coax 1 Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Decode
Options
Coax 2 Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Decode
Options
TOSLINK Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Decode
Options
Digital 16
Channel Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, HI/VI
Source
User 1 Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Input
Select, HI/VI Source, Decode Options
User 2 Input Name, Enable Preset, Preset Level, Input Delay, Rear Surround Source, EQ Set, Input
Select, HI/VI Source, Decode Options
Analog 8
Channel Input Name, Enable Preset, Preset Level, Rear Surround Source, EQ Set, HI/VI Source
Non/Sync Input Name, Enable Preset, Preset Level, Rear Surround Source, EQ Set, Input Trim, Decode
Options
AUX Input Name, Enable Preset, Preset Level, Rear Surround Source, EQ Set, Input Trim, Decode
Options
Mic Input Name, Enable Preset, Preset Level, Rear Surround Source, EQ Set, Input Trim, Mic
Phase
Input Name
The name that is shown on the display and logged when a particular format is selected can be set by the user. Type
a meaningful name for the format in the Input Name field.