USL JSD-100 Manual - Manual (Page 24)

Page 24
USB Driver Removal
To remove the previous JSD-100 USB driver installation,
the JSD-100 must be connected to the computer and
by using Device Manager, the driver will be uninstalled
using the following steps below:
Power on the JSD-100 and when startup is
complete, connect the USB cable to the computer.
Run device manager and locate the “LibUsb
Devices” entry and select the USL JSD-100
Cinema Processor.
Right click the mouse to open the
properties dialog and then activate the
“Uninstall” button.
On Windows 7, check the delete option,
and then proceed by activating the “OK”
button.
Unplug the USB cable and proceed to driver
installation.
USB Driver Installation
The JSD-100 Installation (Setup) program
creates a subfolder called “WinUSB_Drivers”
that will be used for loading the new WinUSB
driver.
Start device manager and then connect the USB
cable to a powered on JSD-100.
Select the USL JSD-100 Cinema Processor from
the device list and right click and select
“Properties.”
Use the “Browse my Computer for the driver
software” option to load the WinUSB driver.
Note that the search automatically option will
reload the old version and will need to repeat
the driver removal process.
Browse to “C:\Program Files\USL\JSD-
100\WinUSB_Drivers” and then proceed to load
the selected driver by activation of the Next
button.
Proceed to load the selected driver by
selecting the “Install this driver software
anyway.”
When the installation completes, the device
manager will now display the USL JSD-100
Cinema Processor under the libusb (WinUSB)
devices. From the GUI the JSD USB device will
appear in the Communications Settings dialog.