USL JSD-100 Manual - Manual (Page 5)

Page 5
1. Safety Notice
Safety Notices
Review the following safety precautions to avoid injury and prevent damage to this product. To avoid potential
risk, use this product only as specified and only for the purpose described in the instruction manual.
To Avoid Fire and Personal Injury:
Use correct power cable. Use only the power cable provided. Ensure that the AC power outlet is located near
the product and is easily accessible.
Use a correctly grounded power source. The power supply earth ground is established through the ground
conductor in the power cable. To avoid the potential of electric shock, the ground conductor must be correct.
Observe source ratings. To avoid risk of fire or electric shock, the power source must be 100 – 240 VAC, 50 –
60 Hz.
Do not operate with suspected failures. If you suspect there is damage or malfunction with this product, call
the factory.
Do not attempt repair. Only a trained factory service person is authorized to repair this product.
Do not operate this product near heat sources. This product should not be located near heat sources such as
radiators, heat registers, or stoves.
Provide proper ventilation. The operating temperature range is between 0º C and 40º C. The humidity range
is between 20% and 80%, non-condensing. The cooling method is convection.
Keep product surfaces clean and dry. Disconnect the power cable from the power source before cleaning.
Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
Do not push objects into openings of this product. Never insert objects into the product through openings.
Do not operate in wet or damp conditions.
Do not operate in an explosive atmosphere.
Inspect the power cable and all cables prior to use. Confirm that the power cable and other interconnecting
cables are free from damage.
2. Regulatory Compliance
EN 60950-1
The EN 60950-1 standard specifies the safety design requirements that reduce or eliminate the risk of personal
injury to both the product user and service personnel. This product is designed and tested to meet the standards
of the International Electrotechnical Commission (IEC) European Norm EN 60950-1, IEC 60950-1 (the standard for
information technology equipment including electrical business equipment).
Le Résumé de la Sécurité general Européen
Examinez les précautions de la sécurité suivantes éviter la blessure et prévenir le dégât à ce produit. Éviter le
risque potentiel, utilisez ce produit seulement comme a spécifié et seulement car le but a décrit dans le manuel
d’instructions.
Éviter Feu et Blessure Personnelle
Utilisez le Câble du Pouvoir Correct. Utilisezseulement le câble du pouvoir fourni. Assurez que lesAC font
fonctionner le débouché est localisé près leproduit et est accessible facilement.
Utilisez une Source du Pouvoir Correctement Fondée.
La terre du monde de la Provision du Pouvoir estétablie à travers le conducteur moulu dans le câble du
pouvoir. Éviter le potentiel de choc électrique, leconducteur moulu doit être correct.
Observez des Estimations de la Source. Pour éviterrisque de feu ou choc électrique, la source du pouvoirdoit
être 220-240 VAC 50 Hz.
N’opérez pas ce Produit avec Toutes Clôtures Ouvertes ou Enlevez.