VACUUBRAND CVC 3000 detect - Manual (Page 63)

page 63 of 74
* If remote operation is selected or deselected, the user has to ensure
that no dangerous status of the system can occur due to the change of
the mode of operation, and must also take appropriate safety precau-
tions, especially if selecting remote operation interferes with a locally
operated active process.
** With command ”ECHO 1” a return value can be activated at write com-
mands. A return value is only given if the command is performed cor-
rectly.
*** After being switched on, the controller is in ”CVC 2” mode by default.
Send ”CVC 3” and ”STORE” to permanently set the controller RS 232C
commands to the extended set ”CVC 3000”.
Accessories
External pressure transducer VSK 3000, ..................................................636657
capacitive, ceramic diaphragm sensor 810 - 0.1 Torr (1080 - 0.1 mbar)
Coolant valve VKW-B, VACUU•BUS ...........................................................674220
Venting valve VBM-B / KF 16, VACUU•BUS .............................................. 674217
VACUU•BUS Y-type adapter ......................................................................636656
VACUU•BUS extension cable, 6.6ft (2m) ....................................................612552
VACUU•BUS wall jack .................................................................................636153
Serial cable RS 232C, 9-pin, Sub-D .............................................................637837
Installation set CVC 3000 (clips and screws) ..............................................636593
Level sensor.................................................................................................699908
(control of liquid level in catchpots)
VACUU•BUS Digital-I/O-Module .................................................................636228
(e.g., fault indicator / remote module)
VACUU•BUS Analog-I/O-Module ................................................................636229
(for analog input and output of vacuum and motor speed)
VMS-B module 100-230V 50/60Hz (with connection cable) ........................676030
PC-Software VACUU•CONTROL .................................................................692920
Use VACUU•BUS Y-adapters and extension cables to connect further
components. When connecting an external pressure transducer, it is
used automatically. Further information on how to use several sensors
simultaneously is available on request.