Canon B155 - Manual (Page 72)

Cancelling Sending
To stop sending before the fax is finished, press [Stop]. Then you may need to open the operation panel
to remove the document. See Clearing document jams, p. 62.
Redialling
j Manual
To start dialling again, just press [Redial/Pause]. (When you press [Redial/Pause], the previous number
dialled with the numeric buttons is redialled.)
j Automatic
The fax automatically redials twice* after the first attempt at sending fails (e.g. the line was busy).
The time between redials is two minutes.*
You can change the number of redials and the time between redials by changing the AUTO REDIAL
setting in the TX SETTINGS (see p. 87).
If the fax fails to get through after the second redial, the fax beeps.
*Factory setting
The LCD displays REDIALLING while the fax is in the redialling process.
j To cancel automatic redialling
You can cancel automatic redialling anytime by pressing the [Stop] button.
However, when memory is used during sending (including Delayed Sending and Sequential
Broadcasting), you cannot cancel redialling while REDIALLING or MULTI TRANS. ON is displayed
on the LCD. In this case, wait until dialling begins, then press [Stop] to cancel redialling.
REDIALLING
SENDING FAXES
60