Veracity OUTREACH QUAD LITE - Manual (Page 2)

Example OUTREACH QUAD applications
Example 1: Four PoE cameras from one switch port
The OUTSOURCE PLUS is located near the network switch and delivers enhanced PoE Plus power to the OUTREACH QUAD. The OUTREACH
QUAD's power budget is sufficient to power up to four conventional IP cameras, which are typically class 2 PoE devices.
OUTREACH QUAD restores the Ethernet signal and forwards PoE, allowing the cameras to be located up to 200 metres (660 feet) from the
switch and power source
Example 2: Three PoE cameras at extended range
The addition of an OUTREACH PLUS means that cameras can be located up to 300 metres (990 feet) from the central switch and power
source. However the reduced budget of 22 watts reduces the maximum number of connected class cameras to three.
The OUTREACH QUAD's spare fourth port can still be used as a network connection, but no further PoE power is available.
Example 3: Adding a new camera to an existing installation
An OUTREACH QUAD and an OUTSOURCE can be used to allow an extra camera to be quickly added to an installation. OUTSOURCE injects
enhanced PoE power to the original cable after the network switch (or PoE network switch).
The OUTREACH QUAD can be inserted at any point along the cable, and allows the new PoE network connection to be “tapped off” the
existing link.
Example 4: Expanding a network using OUTREACH QUAD LITE
OUTREACH QUAD LITE can be used as an edge switch to add Ethernet ports to a network. It does not have to be located near an electrical
outlet as all power is sourced from the central PoE switch, which could be UPS-backed. The extra Ethernet connections can also be
located up to 200 metres (660 feet) from the network switch.
EC Declaration of Conformity
In accordance with EN 45014:1998
We, Veracity UK Ltd. of 6 Barns Street, Ayr, KA7 1XA
declare that the equipment “OUTREACH QUAD” Ethernet repeater
model number S VOR-ORQ and VOR-ORQL
conform to the essential protection requirements of the EMC Directive 89/336/EEC as amended.
The following EMC standards have been applied:
BS EN 55022:1998 Emissions (Class B Radiated)
BS EN 55024:1998 Immunity (BS EN 61000-4-2:1995 Immunity to ESD,
BS EN 61000-4-3:2000 Immunity to Radiated RF Fields (3V/m))
I hereby declare that the equipment named above has been been found to comply with the relevant sections of
the above referenced specifications. The unit complies with all essential requirements of the EMC Directive.
Responsible Person Mr Alastair McLeod, Director
Issued 20th March 2009 at Ayr
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.