Winco Mfg. 5001 - Augustine Treatment Recliner - Manual (Page 5)

Copyright 2014, WINCO MFG., LLC 5
ASSEMBLY INSTRUCTIONS
BACK ASSEMBLY INSTRUCTIONS:
1. Lock casters by pushing down the central-lock lever located at the
rear of chair. (See Lock/Unlock Casters pg.7)
IMPORTANT:
•
Keep objects and persons clear of the chair before performing
step 2.
2. Pull one of the recline levers (A), located on either side of the
chair, until fully extended to bring the recline mechanism (B) into
its upright position.
NOTE: Legrest is spring loaded and will be rapidly released into
the recline position when recline lever is pulled.
3. Release the recline lever and push legrest in, to its stored
position.
PREPARATION:
1. Carefully examine your product for any damage. Inspect all components.
IF DAMAGE IS EVIDENT, REFUSE SHIPMENT, & CONTACT FREIGHT CARRIER OR WINCO IMMEDIATELY.
2. Remove all packaging material that was secured for shipping.
3. Carefully remove the product from the carton.
4. Save all boxes and packaging material until after you have assembled your product and have verified that all com-
ponents are functioning properly.
2
1
A
REAR BRAKE ASSEMBLY INSTRUCTIONS:
This chair is shipped with the central-locking casters in the LOCKED
position.
To assemble the REAR central-lock lever:
1. Loosen thumb screw and slide the lever (A) onto the "HEX" por-
tion of the bar.
2. Tighten thumb screw (B).
3. Lift UP on the lever to UNLOCK the central-locking casters.