Winco Mfg. 5361 - Caremor Recliner - Manual (Page 3)

Page 3 of 4
006170 Rev Q Date 11-08-11 JWC
IMPORTANT
Remove the wooden brace from
back frame before using chair
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco chair. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original
appearance.
Visit our website www.wincomfg.com/product-documents/parts-lists for a complete parts list catalog of your chair or
call Customer Service @ 1-800-237-3377 to request it by mail.
O ptional Release Handle Mounting location:
Tools Needed: Phillips Screwdriver & Flat Screwdriver
1. Use Phillips screwdriver & remove the Release Lever
and screw from the Push Handle.
2. Use Phillips screwdriver & remove the rear screw that
attaches rear of left Side Panel.
3. Use flat screwdriver & remove left Armrest, and then
insert the included flat-head screw into hole with
countersink located on metal arm plate.
4. Route the Release Lever between the Side Panel and
Frame as shown in photo above.
5. Use flat screwdriver & thread flat-head screw into the
Release Lever and tighten.
6. Re-install Armrest.
7. Re-attach rear of Side Panel.
8. Install the included plastic “Split-Stem Cap” in the
empty hole on the Push Handle.
FIG.1
FIG.2
FIG.3 FIG.4