Winco Mfg. 8050/8050SH - Adjustable Treatment Table - Manual (Page 3)

Page 3 of 4
006045 Rev FF Date 06-05-12 JWC
Optional Shelf Installation
14. If your table has a shelf, double-sided tape has been installed on the cross brace of the Welded Leg
Assemblies.
15.
Before removing the paper on the tape, make sure you “test fit” the shelf.
16.
Once you are certain where you want to position the shelf, peel off the paper to expose adhesive.
17.
Carefully position shelf in place on adhesive.
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco table. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original
appearance.
Parts Reference
Do not over tighten nuts and bolts. Periodically check all fasteners for tightness.
After peeling paper from adhesive tape:
Use damp sponge to moisten tape to allow shelf to be adjusted during install.
Once tape is dry shelf will stay in place.
Ratchet Bar
Headrest Adjustment
Assembly - #222650