Winco Mfg. 8510D1 - Treatment Table with Drawers User Manual
Page 2
Page 2 of 4
006065
Rev O Date 06-06-12
JWC
5. With table in the upright position, adjust the four (4) Adjustable Glide Feet to level the table.
6. Use a Phillips bit screwdriver and a 7/16” wrench to check all screws, nuts, and bolts to ensure they are tight
and did not loosen during shipping.
7. Load paper roll onto Paper Holder Rod. Rod must be inserted through Paper Rod Clamps.
Vinyl Strap Adjustment – Should the vinyl strap on your Winco table need to be adjusted, unscrew the screw and
washer that currently holds either side of it in place. Pierce another hole in the strap to give desired tension and
re-insert screws.
You may move the strap to a new location by removing the screws in ends of the vinyl strap and re-installing in the
new location. (It may be necessary to drill 1/16” pilot holes in the wood table bottom to ease re-installation of
screws.)
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco table. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original
appearance.
Do not over tighten nuts and bolts. Periodically check all fasteners for tightness.