Winco Mfg. 8510SH - Treatment Table with Shelf - Manual (Page 2)

Page 2 of 4
006060 Revision X Date 06-06-12 JWC
4. Place (4) ¼-20 x 1-½” carriage bolts into the (4) square holes through the Lower Leg Brace of the Table
Legs. Heads of screws should face the ends of table, for better appearance.
5. Install the Cross-brace. Welds on the Cross-brace must face down toward floor when the table is upright.
Attach with the (4) screws that you just installed on step 4 and secure with (4) ¼-20 nuts.
6.
TIGHTEN ALL nuts & bolts.
7. Install the four (4) Glide Feet completely into the Threaded Inserts located on the bottom of the Table Legs.
Additional instructions for 8510 models ----- (8500 model go to step 11)
8. Attach the Face Slot Tube so that one hole is aligned with the center hole of the Upper Leg Brace (flat side of
Face Slot Tube faces table bottom). Position the opposite end of the Face Slot Tube over the 1” nylon
spacer and the hole in table bottom. Install two (2) 1-3/4” Panhead Phillips screws through both ends of the
Face Slot Tube, then tighten into the wood table bottom with a Phillips Head Screwdriver.
9. Install Face Paper Holder using (2) 1” “drywall-type” screws in pre-drilled holes on either side of Face Slot.
10. Install Face Paper Cutter on Table Frame Rail (where desired) opposite Face Paper Holder. Peel backing
from tape on back of cutter, press cutter firmly into place.
11. Using at least two people, turn table upright.
12. Place
Paper Holder Rod through the (2) Paper Rod Clamps, (with paper roll in-between).
13. Adjust the (4) Glide Feet to level table.
Optional Shelf installation:
14. Double-sided tape has been installed on the Cross-brace.
15. Before removing paper on tape, “test fit” the shelf. Shelf should be approximately ¼” from edges of Lower
Leg Brace.
16. Once you are certain of where you will position the shelf, peel off the paper to expose adhesive.
17.
Carefully position shelf in place on adhesive.
Vinyl Strap Adjustment – Should the vinyl strap on your Winco table need to be adjusted, unscrew the screw that
currently holds either side of it in place. Pierce another hole in the strap to give desired tension and re-insert
screw.
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco table. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original
appearance.
Do not over tighten nuts and bolts. Periodically recheck all fasteners for tightness.
If the Optional Shelf and Reinforced Cross-brace have been ordered; make sure that the smooth
surface (side with tape) of the Reinforced Cross-brace will face upward (when the table is in the
upright position) prior to fastening to the Table Legs.
After peeling paper from adhesive tape:
Use damp sponge to moisten tape to allow shelf to be adjusted during install.
Once tape is dry shelf will stay in place.
After peeling paper from adhesive tape:
Use damp sponge to moisten tape to allow face paper cutter to be adjusted during install.
Once tape is dry face paper cutter will stay in place.