Winco Mfg. 8570SH - Treatment Table with Shelf - Manual (Page 2)

Page 2 of 8
006075 Revision O Date 06-06-12 JWC
6. Install (2) ¼-20 x 2-½” screws and (2) ¼-20 nuts to fasten the unattached Welded leg Assembly to the
Table Frame Rails. Heads of screws should face the sides of table, for better appearance. DO NOT
FULLY TIGHTEN AT THIS TIME.
7. REPEAT Step 4
8. Place (4) ¼-20 x 1-½” screws in (4) holes through the lower leg brace of the Welded Leg Assemblies as
shown. Heads of screws should face the ends of table, for better appearance.
9. Align Welded Brace Assembly (smoothest side up, when the table is in the upright position) with the (4)
screws & holes on both Welded Leg Assemblies and fasten with (4) ¼-20 nuts.
10. TIGHTEN ALL FASTENERS AT THIS TIME. (including the nuts & screws holding the Welded Leg
Assemblies to the Table Frame Rails – see sketch).
11. Install the four (4) Glide Feet completely into the ends of the Welded Leg Assemblies.
12. The release handle for the adjustable back rest, can be installed on the left or the right table frame rail,
depending on user preference.
 Should you wish to change the release handle mounting location, simply remove the (2) Phillips head
screws that attach the handle to the table frame rail and relocate the handle to the opposite table frame
rail and re-install the screws.
13. Using at least two people, turn table upright.
14. Slide the Paper Holder Rod into the (2) Paper Rod Clamps.
15. Adjust one or two of the Glide Feet to level table.
Optional Shelf installation:
16. Double-sided tape has been installed on the Welded Brace Assembly.
17. Before removing paper on tape, “test fit” the shelf. Shelf should be approximately ¼” from edge of Lower
Leg Brace.
18. Once you are certain of where you will position the shelf, peel off the paper to expose adhesive.
19. Carefully position shelf in place on adhesive.
Operation of Table
If the Optional Shelf and Reinforced Welded Brace Assembly have been ordered; make sure that the smooth surface
(side with tape) of the Reinforced Welded Brace Assembly will face upward (when the table is in the upright position)
prior to fastening to Welded Leg Assemblies.
After peeling paper from adhesive tape:
Use damp sponge to moisten tape to allow shelf to be adjusted during install.
Once tape is dry shelf will stay in place.