Winco Mfg. IV Pole and Attachment - Manual (Page 4)

Page 4 of 8
006312 Revision F Date 10-22-13 JWC
●IV Pole Attachment
Models: 2570, 2571, 2572, 2573, 2574, 2575
●Tools needed:
·
Phillips Head Screwdriver
·
7/16” wrench (multiple size wrench included)
·
Powered tools NOT recommended –
●Assembly Instructions
6. Locate the proper location on the chair for the
“IV U-Bracket Assembly”. (FIG.1)
7. Insert the “IV Spacer” into the “IV U-Bracket”
(FIG.2) and place onto chair frame.
8. Insert the two screws through the holes in the
“IV U-Bracket”. (FIG.3)
9. Screw on the nylon lock-nuts and, using the wrench
provided, tighten the lock-nuts to the bracket. (FIG.3)
10. Your chair should look similar to that of (FIG.4)
NOTE:
Left & Right is determined – as if sitting
in the chair
●Parts Included:
Description: Qty. Part Number
IV U-Bracket Assembly 1 227600 (RIGHT)
227605 (LEFT)
IV Spacer 1 227607
1” Grey Cap 2 700700
¼-20 Nylon Lock-nut (1 installed) 3 566204
¾” Phillips-head Screw (installed) 1 566504
2¾” Phillips-head Screw 2 566571
IV Pole 1 480500
FIG. 1
FIG. 3
FIG. 4
FIG. 2