Winco Mfg. O2 - Oxygen Tank Holder - Manual (Page 3)

Page 3 of 5
006321 REV. B Date 09-07-11 JWC
●O
2
Holder Assembly:
6550-6551-(Kit # 227615K), 6570-6571-(Kit # 227617K)
●Tools needed:
•
Phillips Head Screwdriver
•
7/16” wrench (multiple size wrench included)
•
Powered tools NOT recommended –
●Assembly Instructions
1. Locate the REAR RIGHT-SIDE of the chair. (FIG.1)
2. Insert the “Spacer” into the U-Bracket”
(FIG. 2) and place onto chair frame.
3. Insert the two screws through the holes in the
“U-Bracket”.
4. Screw on the nylon lock-nuts and, using the wrench
provided, tighten the lock-nuts to the bracket. (FIG.3)
5. Insert O
2
holder into bracket until the silver snap-button
sits in the notch of the bracket. (FIG.4)
●Parts Included:
Description: Qty. Part Number
O2 U-BRACKET
1 227615
OXYGEN TANK HOLDER 1 250015
IV SPACER (655 model ONLY) 1 227607
1” GRAY SQUARE CAP 2 700700
STAR KNOB 1 201215
1/4-20 x 2 3/4" PHILLIPS-HEAD SCREW 2 566571
1/4-20 NYLON LOCKNUT 2 566204
FIG. 1
IMPORTANT:
The “Spacer” is for the 655 model ONLY
and should be placed as shown.
(FIG.2)
FIG. 3
NOTE:
Left & Right is determined – as if sitting
in the chair
FIG. 2
FIG. 4