General maintanence, General care & cleaning – Winco Mfg. S400 - Transfer Recliner User Manual
Page 4
Page 4 of 8
006195
Revision GG Date 06-28-13
JWC
GENERAL MAINTANENCE:
The Transfer Recliner is completely assembled and ready for use, however, to extend the life of your Transfer
Recliner, and to insure proper operation, lubricate all pivot points with a silicone lubricant at least twice a year.
· FIG. 6: Adjusting Gas Spring:
If the back of your Transfer Recliner does not recline
when you squeeze the Control Lever; you may need to
make an adjustment to the operator (located on the end
of the gas spring).
NOTE: Tension or “ease of movement” of gas
spring is factory set and CANNOT be changed.
1. To adjust, remove cable (A) from operator (B) - (if
not connected - STOP: reconnect and try Control
Lever again).
2. Loosen the 11/16” hex nut (C) on top of the
Operator.
3. Remove clevis pin and bowtie cotter pin (D).
· If back of recliner does not go into the “flat” or full
recline position, rotate the Operator (E) clockwise
one (1) full revolution.
· If back of recliner will not stay in upright position,
rotate the Operator (E) counter-clockwise one (1) full revolution.
4. Tighten the hex nut (C) on gas spring, replace release cable (A) into operator (B) and check lever action.
5. Repeat these steps as needed until proper “back release action” is achieved.
GENERAL CARE & CLEANING
Remove hair & body oils; Your recliner should be cleaned with mild soap & water solution and a damp
cloth on a regular basis (especially where skin & hair make contact with upholstery).
Avoid harsh detergents or chemicals that could damage the upholstery or finish of your recliner. If the recliner is
disenfected, the chair MUST be wiped off with ONLY clean water on a damp cloth.
Note: Disinfectants alone, will not provide adequate "grease or oil cutting" properties to remove hair & skin oils.
Over time, the appearance and feel of your upholstery may diminish if not cleaned properly.
Please refer to the PERMABLOK instruction tag that is attached to your Care Cliner for complete care and
cleaning instructions.
Retain information on tag for future use.
FOR FURTHER CLEANING INFORMATION VISIT:
FIG. 6
CAUTION:
DO NOT squeeze operator (B) during this procedure.