Winco Mfg. 5111 - Activity Chair - Manual (Page 2)

Page 2 of 4
006085 Rev L Date 11-08-11 JWC
4. Slip the Back Frame over the Seat Frame Rail ends until the holes in Back Frame line up with the holes in
the Seat Frame Rails.
5. Insert the (2) screws you removed in step 2, into the aligned holes of the Back Frame and Seat Frame.
6. Tighten these screws firmly. Failure to install these screws MAY RESULT IN SERIOUS INJURY.
Operation of the Tray: 5101 ONLY
7. Tray Arms are inserted into the Tray Receiving Tubes (under Armrests on chair). The Tray automatically
locks into the first position, depress the Snap Button (on Right Tray Arm) for 2 more positions.
NOTE: Left and right; As if you are seated in chair.
8. The
Right Tray Arm is movable to compensate for minor variations in the width of the chair.
9. Storing the Tray; Insert the LEFT tray arm tube INTO the RIGHT tray receiving tube and the Latch Button
will lock it into place. Allow the right side of the table to hang down vertically on the right side of chair (Left &
Right; as if you are seated in chair).
10. To make the tray permanently “non-restraint”, remove the Snap Button of the Right Tray Arm.
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco chair. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original
appearance.
Visit our website www.wincomfg.com/product-documents/parts-lists for a complete parts list catalog of your chair or
call Customer Service @ 1-800-237-3377 to request it by mail
Periodically recheck tightness of all screw and bolts, and never use the chair arms or tray as a seat or the
tray as a restraint.