Zipper's Performance 309-575 - Manual (Page 10)

Thunder Heart Performance Corp. 615-672-8811 www.thunder-heart.com
8. To program the other features of the Digital Ignition Module, use the
MODE and “arrow” buttons. The following is a list of each feature and its
range:
Initial Advance (Initial Adv) is the ignition timing in crankshaft degrees
(before top dead center), the module will use until 1000rpm.
Range: 5-20 degrees
Maximum Advance (Maximum Adv) is the ignition timing in crankshaft
degrees (before top dead center), the module will use as its maximum value.
Range: 24-45 degrees
Maximum Advance RPM (Max Adv RPM) is the engine speed (in RPM X
100) that the ignition reaches its maximum advance value. A lower RPM
makes the advance slope “steeper.”
Range: 2000-5300 RPM
Rev Limit Activation (Rev Limit) is the engine speed (in RPM X 100) that
the ignition’s main rev limiter is activated. Under acceleration, the engine will
not rev past this point.
Range: 5100 to 8000 RPM
Shift Light Activation (Shift Light) is the minimum engine speed (in RPM X
100) the ignition will supply a 12v+ signal to the red w/yellow stripe auxiliary
output wire.
Range: 5100 to 8000 RPM
2-Step Rev Limit Activation (2-Step) is the engine speed (in RPM X 100)
that the ignition will limit the engine when the yellow w/black strip auxiliary
input wire is grounded (useful for drag racing).
Range: 2000 to 5100 RPM
4.2 Ignition Programming Using (Available Separately)
SmartLink Software and Interface Cable
To program the Digital Ignition Module with the SmartLink Software and
Interface Cable, please refer to the instructions supplied with that kit.
CHAPTER 5 IGNITION OPERATION
When the motorcycle is running, the current ignition timing will appear on the
display.
6
309-575 TH-Zip Ignition.doc