Precautions & general maintenance, Cd maintenance, Recorder maintenance – Philips AZ241517 User Manual

Page 15: Maintenance

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

MAINTENANCE

PRECAUTIONS & GENERAL MAINTENANCE

Place the set on a hard, flat surface so that it does not tilt.

Do not expose the set, CDs, batteries or cassettes to humidity,

rain, sand, direct sunlight or other places where high temper­

atures can occur, such as in the vicinity of heating apparatus

or in motor cars parked in the sun.

Do not cover the set. The amplifier produces heat which must

dissipate freely, so make sure that there is sufficient

ventilation around the set. A minimum gap of 15 cm is

necessary.

The mechanical parts of the CD player and the cassette deck

contain self-lubricating bearings and must not be oiled or

lubricated.

A chamois leather slightly moistened with water is sufficient

for cleaning the housing. Do not use cleaning agents

containing alcohol, spirits, ammonia or abrasives as these

may harm the housing.

03

c

LU

CD MAINTENANCE

- The lens of the CD player should never be touched.

- The lens may cloud over if the CD player is moved from cold

to warm surroundings. The CD player will not start. Give the

player some time to acclimatise.

- To take a CD out of its box, press the centre spindle while

lifting the CD. Always pick up the CD by the edge and replace

the CD back in its box after use to avoid scratching and dust.

- To clean the CD, wipe in a straight line from the centre

towards the edge using a soft, lint-free cloth. Do not use

cleaning agents as they may damage the disc.

- Never write on a CD or attach stickers to it.

RECORDER MAINTENANCE

To ensure a good recording and playback quality, clean the

indicated parts ®,(|) and (c) after every 50 hours of operation

or, on average, once a month. Use a cotton bud slightly

moistened with alcohol or a special head cleaning fluid.

• Open the cassette door by pressing STOP»DPEN HA.

• Press PLAY ► and clean the rubber pressure rollers ©.

• Then press PAUSE II and clean the capstans ® and the

heads ®.

• After cleaning, press STOP»DPEN H

A.

Note:

Cleaning of the heads ® can also be done by playing a

cleaning cassette through once.

Advertising