Digital tuner, Tuning to radio stations – Philips AZ241517 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DIGITAL TUNER
m
s
ca
TUNER
AM tuning step (some versions only)
In North and South America the frequency step between adjacent
channels in the AM band is 10 KHz. In the rest of the world this
step is 9 KHz. Usually the frequency step has been preset in the
factory for your area.
To change the tuning step.
1.
Press the POWER button to switch on the set.
2.
Keep the BAND selector pressed for 5 seconds or more.
The display shows either S'
C
<-
d
or /
D G >-: d.
-
All preset stations will be lost and need to be programmed
again if you decide to set the tuning step during use.
TUNING TO RADIO STATIONS
1.
Select TUNER using the CD-TAPE-TUNER button.
2.
Press BAND to select your wave band.
Tune to radio stations, press TUNING control r« or>w on the
set until the frequency on the display starts running, before
releasing your finger from the control.
—The radio automatically tunes to a station of sufficient
reception and
Bred
appears on the display.
3.
Repeat if necessary until you find the desired station.
- Tune to a weak transmitter, briefly press TUNING or
until you have found optimum reception or the correct
frequency is shown on the display.
- When STERED appears on the display, you are receiving a FM-
stereo transmitter.
To improve radio reception:
- For FM, pull out the telescopic aerial. Incline and turn the
aerial. Reduce its length if the signal is too strong (very close
to a transmitter).
- For AM, the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning
the whole set.
-
5r c h