Sears 72671 - Manual (Page 30)

Care and Cleaning
(continued)
Broiler Pan and Grid
After broiling* remove tbe
broiler pan from eke oven
or broiler compartment
(dependine on your model).
Remove die grid from the
pan. Carefiilly pour our
grease from the pan into a
proper container. Wash and
rinse the broiler pan and grid in hoc water with a
soap-filled or plastic scouring pad.
If food has burned on, sprinkle the grid with detergent
while hot and cover with wet paper towels or a dishcloth.
Soaking the pan will remove burned-on foods.
Both the broiler pan and grid can also be cleaned in a
dishwasher.
Do not store a soiled broiler pan and grid anywhere
in the range.
CAUTION: Do not clean the brofter pan or grid in
a self-cleaning oven.
Oven Shelves
Clean the shelves with an abrasive cleanser or steel
wool.
After cleaning, rinse the shelves with clean water
and dry with a clean cloth.
NOTE: Take the shelves out of the oven before you
begin the self-clean cycle.
Oven Bottom
The oven bottom has a
porcelain enamel finish.
To make cleaning easier,
protect the oven bottom
from excessive spillovers by
placing a cooicie sheet on
the shelf below the shelf
you are cooking on. You
can use aluminum foil if
you do not cover the whole shelf. This is particularly
important when baking a fruit pie or other foods with
a high acid content. Hot fruit fillings or other foods
that are highly acidic (such as tomatoes, sauerkraut and
sauces with vinegar or lemon Juice) may cause pitting
and damage to the porcelain enamel surface and
should be wiped up immediately.
To clean up spillovers, use soap and water, an abrasive
cleaner or Lp-fdled ¡reel wool pad. Rinse well to
remove any soap before self-cleaning.
Surface Light and Starter
(on some models)
Canopy.
Lift up
Starter
bulb
CAUTION: Do not
touch the bulb with wet
hands or when bulb is
hot. Never wipe the
light area with a wet
cloth. Electrical power
must be shut off if you
have to replace a bulb.
To replace the bulb:
1. With one hand at each
end of the hinged
canopy, grasp it by die
front edge and flip it up.
2. Remove the fluorescent light bulb. Replace the bulb
with one of the same length and wattage.
3. Lower the canopy.
To replace the starter:
1. Open the canopy and remove the bulb as
explained above.
2. Grasp the starter, mrn it counterclockwise about
one-quarter turn and lift our. Replace with one of
the same wattage.
30 3, Replace the bulb and lower the canopy.